LT39-II、LT412-II、2MD-II安装说明:
Directions for Installation of LT39-II、LT412-II、2MD-II
一、 平衡体的安装(图一)
I. Installation of equipoise (Fig. 1)
旋转体安装后,即可安装平衡体。先联接旋转体与平衡体间的接插件,然后用螺钉接旋转体与平衡体并旋紧。
Install the equipoise after the installation of revolver. First connect the connector assembly between the revolver and equipoise prior to connecting the revolver to the equipoise with screws and tightening them.
二、 灯头的安装(图二、三)
II. Installation of lamp holder (Fig. 2, 3)
1、用螺丝刀卸下灯架上的塑料盖及自攻螺钉、取出电线接插件。
2、取出平衡体端轴电线接插件,穿过灯架轴孔,套入平衡体端轴后用螺钉旋紧。
3、接上接插件,用螺丝刀和自攻螺钉将塑料盖安装在灯架上。
4、调整阻尼力,使灯头旋转平稳。
5、十二孔灯头装上拉手杆,用螺钉联接。
1. Remove the plastic cap and self-tapping screws from the support with a screw-driver and take out the wire connector assembly.
2. Take out the wire connector assembly of equipoise end-shaft to lead it through the shaft hole of support and put on the equipoise end-shaft prior to tightening it with screws.
3. Connect the connector assembly and install the plastic cap to the lamp support with the help of a screw-driver and self-tapping screws.
4. Vary the damping force to ensure the lamp holder rotate stably.
5. Connect the pull rod to the lamp holder w/ 12 reflectors with screws.
<
|