温控仪操作指南 Directions for Temperature Controller
温度设定:在正常状态下按一下功能键“SET”,下排副显示窗的某一数字开始闪烁,再按加数键“▲”减数“▼”和移位键“◥”,即可进行仪表规定量程范围内任意值的设定,当下排显示窗的数值变成你所需要的值后,再按一下功能健“(SET)”重新设置的值即输入仪表,仪表开始按新输入的温度进行自动调节。
自整定设定:当温度控制效果不够理想时,可以通过自整定来改变PID参数,操作方法如下:按SET键5秒,进入B菜单,设置AT=1,AT灯亮,退出B菜单,系统即进入自整定状态,经两个周期波动后,自整定过程结束,AT灯熄灭。此时PID参数已调整完毕。
报警设置:按“SET”5秒后,下排副显示窗的某一数字开始闪烁,再按加数键“▲”减数“▼”,当副显示窗数码管为“ALI”时松开,再输入想要的值即可。
Directions for Temperature Controller
Temp Setting:Under normal condition, hold down function key “SET” to make the number shown in the secondary display flickering, followed by pressing Increase Key “▲” ,Decrease Key“▼” and shift key“◥” to chose any desired value within the specific range . Once the desired value has been shown in the display screen, you can hold down “(SET)” for second time to enter the new value and the instrument will run automatically depending on this value.
<
|